Home of the GrumpyGeek

One more step…

I got a little time last Wednesday to work on the machine, so I went ahead and built the table top.  It consists of of a 59.5 inch x 24 inch sheet of 3/4 MDF that has (3) 56.5 inch sections of  .75 Inch EMT conduit attached to the bottom for support.   The conduit is attached by (5) .25 inch x 2 inch screws spaced 13 inches from each other that are counter sunk into the table.  The table is attached to the machine using 6 more of the .25 inch by 2 inch screws that attach to 3 cross dowels in each end of the machine.  Nothing too exciting, but its another step down.

Completed table attached to machine
Completed table attached to machine

Underside of table
Underside of table
Side View
Side View
Rear View
Rear View
Front View
Front View

Leave a reply