I got a little time last Wednesday to work on the machine, so I went ahead and built the table top. It consists of of a 59.5 inch x 24 inch sheet of 3/4 MDF that has (3) 56.5 inch sections of .75 Inch EMT conduit attached to the bottom for support. The conduit is attached by (5) .25 inch x 2 inch screws spaced 13 inches from each other that are counter sunk into the table. The table is attached to the machine using 6 more of the .25 inch by 2 inch screws that attach to 3 cross dowels in each end of the machine. Nothing too exciting, but its another step down.
![Completed table attached to machine](http://grumpygeek.com/wp-content/uploads/2010/01/Table1-300x225.jpg)
![Underside of table](http://grumpygeek.com/wp-content/uploads/2010/01/table2-225x300.jpg)
![Side View](http://grumpygeek.com/wp-content/uploads/2010/01/TableSideView-300x225.jpg)
![Rear View](http://grumpygeek.com/wp-content/uploads/2010/01/TableRearView-300x225.jpg)
![Front View](http://grumpygeek.com/wp-content/uploads/2010/01/TableFrontView-225x300.jpg)